COMPLETION DATE CASING SIZE WELLBORE SIZE CASING WEIGHT UPPER SET DEPTH LOWER SET DEPTH CEMENT SACKS TEST PRESSURE HOURS UNDER PRESSURE TEST DATE CASING PULLED CREATION PROCESS
07/21/2010 0758 0978 29.7 12302 1534 7600 .05 07/03/2010 WELL HISTORY
07/21/2010 1034 1312 45.5 2120 868 1500 .5 05/24/2010 WELL HISTORY

Les B, SkipPeel or Baron,

 

Please explain the terms and numbers on this Sonlite table so a non oil/ng person can understand!

 

Views: 69

Reply to This

Replies to This Discussion

LWC,

Line 1 - 7 & 5/8 inch diameter casing set to 12302 ft depth in a drilled hole with a 9 & 7/8 inch diameter. This would be the intermediate casing string installed in the vertical section of the welbore before drilling curve and horizontal lateral. Cemented in place and tested to 7600 psi of pressure (for 3 minutes?).

Line 2 - 10 & 3/4 inch diameter casing set to 2120 ft depth in a drilled hole with a 13 & 1/2 inch diameter. This would be the surface casing string. Cemented in place and tested to 1500 psi of pressure (for 30 minutes?).

The casing weight just gives some indication of the thickness but I will leave that to a drilling expert.
LWC,

7-5/8 casing with 29.70 lbs/ft weight has a wall thickness of 0.375 inches and inside diameter of 6.875 inches.

10-3/4 casing with 45.50 lbs/ft weight has a wall thickness of 0.400 inches and inside diameter of 9.950 inches.
Les B and FXEF thank you very much. I figured some of this out but was unclear about the test pressure/time. Thanks again.

RSS

Support GoHaynesvilleShale.com

Not a member? Get our email.

Groups



© 2024   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service