Replies to This Discussion

Permalink Reply by Gale on June 27, 2012 at 13:25

Doubt there will be any beckville billionaires LOL but a nice little oil well for a yr or two would be welcome.

Permalink Reply by Gale on June 12, 2013 at 19:07

Update Kathy,

As it turns out you were right in that this was good news for us, Chevron has drilled the first of three permitted Oil Wells for us with Good results. They are in Travis Peak and Horizontal wells. Needless to say I'm excited, now I've contacted the small company holding our lease across the rd and ask then to get it drilled as well. We shall see. LOL

Permalink Reply by jffree1 on June 14, 2013 at 6:50

I suspect that this is the reason why. Note the liquids being produced from this hz. Haynesville well.

Anadarko has made a couple of statements about the liquids being recovered from some of their HA wells but so far they are not including those figures on monthly production reports.

Attachments:

• EOG-Parker Unit #3H Prod..docx, 19 KB

Permalink Reply by dbob on June 25, 2012 at 5:54

I've attached the completion report on the Shivers A 2H.  There is also a similar report for another Chevron/Shivers well.  Looks to be about a 2000' long lateral in Travis peak, with a modest (6 stage) frac, if I read the numbers right.  Some acid in the frac as well. 

Attachments:

• cmpl_RptForm_cmplusr_1340643064526.pdf, 22 KB

Permalink Reply by adubu on June 25, 2012 at 10:15

dbob and jffree1 --- I quess there has been a Horz TP well drilled--- interesting

Permalink Reply by dbob on June 25, 2012 at 16:07

Looks like they have drilled several, all with recent reports, in areas with historic wells.  No real way to gauge production fall-off yet as production from these new completions doesn't appear to have made it to the PDQ yet.  If these things have any type of reasonable curve, they are going to be very cost efficient/high ROI

Attachments:

• cmpl_RptForm_cmplusr_1340678172405.pdf, 22 KB

Permalink Reply by jffree1 on June 26, 2012 at 1:53

I found production (April only) for the S.E. Matthews A 2H.  It's is reported in the Cotton Valley but was permitted in Travis Peak 6400. 

W-1: http://webapps.rrc.state.tx.us/DP/drillDownQueryAction.do?fromPubli...

We should be able to find production back to Nov. unless the well was shut in after the test for some reason.  

Attachments:

• 365-37779 Production.docx, 14 KB

Permalink Reply by Dixie Conley on November 19, 2012 at 14:24

How do I do this?

Permalink Reply by dbob on November 19, 2012 at 16:41

Dixie

ideally, you'll need to know the name of the well (or the RRC assigned lease # or API #) the operator, and the county.  using the RRC  production data querry: http://webapps.rrc.state.tx.us/PDQ/home.do

You should be able to drill down to your well of interest, and review the production history since roughly 1993 or when the well first started producing, whichever is later.  Generally, the RRC website is updated a few months after the production occurs, so for instance, July or August is probably the most recent data available.  

Permalink Reply by Dixie Conley on November 20, 2012 at 1:57

Thank you so much!

• ‹ Previous
• 1
• 2
• Next ›
• Page