I have been following some wells in my area and it appears from production logs that one has fallen off harder than the decline rates would predict. I can see the initial choke (20/60) but wonder is there a way to tell if they've choked the well down more. Ecanan owns the well and have stated they are choking production down, which is another reason I believe it's happend. The well is #238820. Thanks.

Views: 50

Reply to This

Replies to This Discussion

Logan, there is not sufficient information available to draw a conclusion regarding the performance of this well.
Well, at least it's not bad news then lol. Thanks.
I just heard that a new Questar well that IP'd at 25mmcfd and originally planned to be dialed back to 10mm is now being choked back to 3 or 4mmcfd. The taps are turning off, or at least waaay down.
Bacon,
If I were participating in this well, I'd be happy to have it choked back. With gas at $3, royalty checks don't look so good. If I could wait a couple of years and get $6, I'd be happy to wait.

What I don't know is this: Does choking these wells back have any effect on the EUR? Does this hurt the total production from the well in any way?
Henry, for shale wells there should be no reduction in the ultimate recovery related to restricting the flow rate. Typically there is more of a concern that flowing at too high a rate could damage the well and/or formation. This is is reason Haynesville Shale wells are normally produced on a restricted choke (ie 24/64") during their early life. Over time the choke size can be increased to full open.
Les,
Thanks. If that's the case, I'd be happy to be choked back, rather than selling my gas at $3.
One thing that was mentioned today (from a second hand source) was that they suspect that with the higher flowing wells, they are losing proppant from the frac. Increasing the rate of decline.
Ruby, when natural gas is "rich" the chilling effect of the pressure drop can result in some hydrocarbon condensate. These liquids are not a problem for producing wells because it is normal and they are recovered in the production separator and sold at a high price. The Haynesville Shale is very "lean" gas and unlikely to generate any significant volumes of condensate.

By the way, there is always some level of choking required to drop the flowing pressure (ie 5000 psi) down to line pressure (ie 1200 psi).

Some wells will utilize line heaters to avoid problems with hydrate formation due to this chilling effect.

RSS

Support GoHaynesvilleShale.com

Not a member? Get our email.

Groups



© 2024   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service