Replies to This Discussion

Permalink Reply by kittycatmama on August 12, 2010 at 11:04

New road being cleared off Hwy 5 going north into Sec. 18. Any idea what is up? Perhaps a pipeline row

Permalink Reply by Bob and Lisa on August 12, 2010 at 16:31

where is this at off hwy 5 ?

Permalink Reply by kittycatmama on August 12, 2010 at 23:58

Go east on 5 at Kickapoo. It is about 1/2 mile down on north side of road. It is wide enough to be a road, but could also be a pipeline row

Permalink Reply by Bob and Lisa on August 13, 2010 at 4:20

That road is being done by Steve Kent, so I would tend to think it will be a pad site for either 18, or 21.

Permalink Reply by FXEF on August 13, 2010 at 4:37

This road is for a well in section 20.

241749 HA RA SUW;LAND & KNOWLES 20 H #1

Permalink Reply by kittycatmama on August 14, 2010 at 11:38

FXEF, have you heard any production numbers for this well in Sec. 18? Sections 6/7 supposedly flowed at near 20mcfd during July and now down to 15mcfd. This is coming from a reliable source. I would think that Sec.18 is also a good well

Permalink Reply by FXEF on August 14, 2010 at 12:42

kittycatmama,

Flowback has not started yet. Pipeline is in the ground, but Ritter is still working at the well site. Should be flowing soon.

Permalink Reply by kittycatmama on August 14, 2010 at 13:14

FXEF, there was no option to reply to you (I notice that happens on this site sometimes). You seem very knowledgeable about gas business. Think about this, Encana is the operator in Sections 6.7,8,9,17,18,19,20. With pads in all these areas, they could diagonolly drill into each section from these multi pads. It could be the ultimate gas factory

Permalink Reply by FXEF on August 14, 2010 at 14:01

kittycatmama,

I don't have any credentials, I'm still in the learning curve. To keep with the 80 acre spacing and north/south lateral, most likely we will not see any diagonals. I believe in this area that north/south laterals has proven to give better production numbers.

Permalink Reply by Les Bamburg on August 14, 2010 at 17:15

FXEF, KCM may be making reference to drilling directionally down to where the horizontal lateral begins. For example a drilling pad located in the southest corner of Section 18 could be utilized to drill 4 wells each in Sections 17, 18, 19 & 20 with each well having a north-south horizontal lateral.

Permalink Reply by Eliza on August 14, 2010 at 15:50

Encana also has the rights in sections 21 & 22 - T14N14W. Unfortunate reminder (for me) the well they drilled in Section 21 is a vertical and they have not yet drilled in Section 22.

Permalink Reply by kittycatmama on August 15, 2010 at 2:20

Les, FXEF that is what I meant. Guess I used the wrong terminology. I drew out all the sections Encana has out here (didn't realize they also had sections 21 & 22). Think of the possibilities for drilling. They have most pipelines in place. This was not a coincidental. It is like pieces of a puzzle falling into place. The centerpoint huge pipeline goes through the area, the new Tiger line is being built.

• ‹ Previous
• 1
• …
• 3
• 4
• 5
• 6
• 7
• …
• 13
• Next ›
• Page