Replies to This Discussion

Permalink Reply by Les Bamburg on April 27, 2009 at 2:57

Bill, I would suggest you check the following forum for current rig locations:

http://haynesvilleshale.ning.com/group/drillingriglocations/forum/t...

Also, the following well has been drilled in your area and tested at 5.1 MMcfd initial gas rate.

Chesapeake, Percy Arnold Sharp III 7 #H1 Well, Serial #238043, S7-T18N-R15W

Permalink Reply by Bill Brooks on April 27, 2009 at 14:00

Thanks Les B. At work now but will check later. Not sure of my Section. I see I have.a lot to learn.

Permalink Reply by RAY on April 28, 2009 at 12:48

T 18 R 15 S 24

offer of........ $1000 / 25 %......from Twin Cites who represents
Cheasepeake.

Permalink Reply by SharonB T18N R15W S8 on April 29, 2009 at 7:06

There are 18 well pads visable from the air off of Blanchard Furrh Rd between Blanchard and Longwood per my friend. The Sharp well noted below is in the section with the Walter B. Jacobs Nature park. They have put a compressor station in my section (8) and there is a long well site road that starts in section 8 also. You'll know when they are going to drill your section because you'll get a notice of proposed Unitization etc.

Permalink Reply by SharonB T18N R15W S8 on April 29, 2009 at 7:07

There are 18 well pads visable from the air off of Blanchard Furrh Rd between Blanchard and Longwood per my friend. The Sharp well noted below is in the section with the Walter B. Jacobs Nature park. They have put a compressor station in my section (8) and there is a long well site road that starts in section 8 also. You'll know when they are going to drill your section because you'll get a notice of proposed Unitization etc.

Permalink Reply by Bill Brooks on May 1, 2009 at 3:28

Thanks so much for your response. As I said, I am new to this, still trying to learn, which I see is a lot.