Replies to This Discussion

Permalink Reply by Skip Peel - Mineral Consultant on August 27, 2014 at 5:02

Ed, there is already a discussion thread on this well in the Union Parish Group.  There is no rule against having two threads on the same topic but it does pose some problems with replies and information not being posted in the same place.  I am going to post a link to your discussion, here, and close my discussion to replies.

Permalink Reply by Skip Peel - Mineral Consultant on August 29, 2014 at 16:21

Energy Drilling #1 reported 11 days Drilling Ahead @ 6273', 8/29.

Permalink Reply by Skip Peel - Mineral Consultant on September 6, 2014 at 4:53

Energy Drilling #1 reported 18 days Drilling Ahead @ 8700'', 9/5.

Permalink Reply by UP 101 on September 7, 2014 at 8:07

what are the chances of this well being productive?

Permalink Reply by Rock Man on September 7, 2014 at 8:09

Probably a good chance of SOME production but volumes / economic viability won't be determined until well is tested.

If operator doesn't like test results, plugging is always a possibility

Permalink Reply by UP 101 on September 7, 2014 at 8:19

Why not wait an drill upon completion of seismic survey? Heard this was the area that seismic initially started a few months ago.

Permalink Reply by obed w odom on September 7, 2014 at 9:27

This well is in the section immediately east of the Weiser-Brown discovery well, so it is not a big step-out. You are right that it is included in the proposed seismic survey, but SWN may not share seismic results with Weiser-Brown.

Permalink Reply by UP 101 on September 7, 2014 at 14:46

Is this well located on part of the refuge?

Permalink Reply by Skip Peel - Mineral Consultant on September 12, 2014 at 15:21

Energy Drilling #1 no longer reporting, well should be at TD.

Permalink Reply by obed w odom on September 17, 2014 at 8:17

SONRIS Lite report of 9/15/2014:

9/2/14, SET 7 5/8" CASING AT 8700' WITH 775 SACKS OF CEMENT. 9/15/14, WAITING ON RIG.

http://sonlite.dnr.state.la.us/sundown/cart_prod/cart_con_wellinfo2...

Permalink Reply by UP 101 on September 14, 2014 at 4:12

What does TD stand for?

Permalink Reply by Skip Peel - Mineral Consultant on September 14, 2014 at 4:16

It's one of those industry standard phrases, Total Depth.  An indication that the rig will drill no further.  Reaching Total Depth usually doesn't quite end the rig's work though.  The last part of their job is to set the final casing string except in the case of an open hole completion.

• ‹ Previous
• 1
• 2
• 3
• Next ›
• Page