Replies to This Discussion

landownerPermalink Reply by Worn Out N1 on July 28, 2010 at 8:09

I thought, in most cases, that unit boundaries followed section lines for gas wells.

Oil & Gas ProPermalink Reply by Les Bamburg on July 28, 2010 at 9:01

WO, you are correct that most Haynesville Units correspond with sections. There are a few exceptions in areas that extend below major water bodies or that are adjacent to the Louisiana state line.

Permalink Reply by treeman on July 28, 2010 at 15:39

Les, would this area be in Haynesville and Bossier shale areas? Seems like a lot of FAST unit permitting . treeman

Oil & Gas ProPermalink Reply by Les Bamburg on July 28, 2010 at 16:38

Treeman, I think this area has a real good shot at being productive in both the Haynesville and Bossier Shale formations. We just need to see the results from a well drilled in T9N-R10W and a couple in T8N-R11W.

landownerPermalink Reply by Seth Bell on July 29, 2010 at 4:12

Does anyone have an update on the drilling progress of the Charles Davis 27H well (Serial #241118) being drilled around the boundary of Sections 22 and 27 of T9N-R10W? No information has been posted to Sonris since it was permitted on or about 3/31/10.

Oil & Gas ProPermalink Reply by Les Bamburg on August 1, 2010 at 4:09

Seth, information indicates this well has not yet spud (drilling started).

• ‹ Previous
• 1
• 2
• Next ›
• Page