We have been asked to grant a subsurface easement for wellbore purposes for a well that will be drilled in an adjacent section. They propose drilling approximately 270 feet across our property line and 5000-9000 feet below. Is there a going rate for this type of easement and how much would that be? Two wells will be drilled. Will the same radius and easement be used for both wells or does each well require their own radius and easement? What should I be looking for in terms of an agreement? Any and all help is greatly appreciated. Thank you in advance.

Views: 265

Replies to This Discussion

Dixie, wellbore easements are pretty rare these days.  I assume that your minerals are not leased.  If so, this becomes a question of the fair market value of the easements but also whether these wells will in any way inhibit when it comes time for your section to be developed.  I think that what you need is an experienced O&G law firm that can advise you.  I think that would be money wisely spent.

Skip, Thanks for your reply. Our minerals are leased. The person that called did not call it a wellbore easement. After doing some research, that is what I called it.  The caller only said they wanted a subsurface easement and it would be the feet and depth as stated in my original post. Am I wrong in calling it a wellbore easement? Since they are within the 330 feet from the section line, on our side of the line, will it still possibly impact drilling in our section. They are in the southwest corner of Sec 15 and we are in the northwest corner of section 22.Thanks again.

Dixie, the reason that we see few requests for subsurface easements these days is because most sections within the Haynesville Shale fairway are under lease and as such an operator wishing to drill from an off unit surface location in a section/unit they do not operate will get permission from the lessee/operator of that section/unit, not the mineral lessor.  I think you might want to contact the company that does operate your section/unit and see what they think.  Even though the requested  lateral slot is within the 330' unit boundary set back,  well spacing is critical and operators with wells in close proximity one to the other need to communicate and cooperate to avoid frack hits which can be a problem.  You can ask whomever is contacting you about this if they have contacted your unit operator.

I will do that, thank you very much for your input.

RSS

Support GoHaynesvilleShale.com

Blog Posts

History of GoHaynesvilleShale

The History of GoHaynesvilleShale.com

GoHaynesvilleShale.com (GHS) was launched in 2008 during a pivotal moment in the energy industry, when the Haynesville Shale formation—a massive natural gas reserve lying beneath parts of northwest Louisiana, east Texas, and southwest Arkansas—was beginning to attract national attention. The website was the brainchild of Keith Mauck, a landowner and entrepreneur who recognized a pressing need: landowners in the region had little access to…

Continue

Posted by Keith Mauck (Site Publisher) on May 21, 2025 at 6:00

Not a member? Get our email.

Groups



© 2025   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service