Adams County MS horizontal well

Does anyone have any insight into the MS Oil and Gas Board docket item yesterday regarding a permit to drill a well with a horizontal component to "test the Austin Chalk formation" in Adams County MS 5N2W sect 17-18? Proposed well on 980@ unit would be to 11,500 ft.. Exceptional location because of "topographical and geologic reasons". Would a well of that depth in that location also penetrate/test the TMS? I realize the North Bayou Jack Field is Austin Chalk not too far west, but also the Crosby TMS well is not too far south. This may be an interesting well for SW MS. Anyone on here have knowledge/thoughts?

Views: 7259

▶ Reply to This

Replies to This Discussion


Oil & Gas ProPermalink Reply by Noah Brenner on February 26, 2015 at 11:40

That whole acreage position in Adams and Wilkinson (43k gross) was being marketed as a TMS/Tuscaloosa sands/AC/Wilcox/Selma prospect at the NAPE Expo in Houston a couple weeks ago- EXXI didn't seem like they had further plans for the area......


Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on February 26, 2015 at 11:45

Thanks for the update, Noah. It will be interesting to see if the prospect gets picked up.


Oil & Gas ProPermalink Reply by Ron Russell on February 27, 2015 at 6:21

Lower Tuscaloosa production in the area (Beverly Field) is around 10,900. TMS is above it.

RSS

© 2026   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service