Haynesville Production Decline vs. Royalty Calculator Estimates

Shalers,

I hear that Haynesville wells are supposed to decline a great bit after the first year...but have wells been in production long enough to prove this?

When I go to natural gas royalty calculators on the internet they don't make provision for such steep declines, and I suppose the reason for not doing so is that they are set on 'average well decline'. Is there a place to go to estimate royalties from the Haynesville?

Thanks,
Jeff in Belgium

Views: 183

▶ Reply to This

Replies to This Discussion

Permalink Reply by Jon Williamson on April 21, 2009 at 7:09
Now that I think about it. I would probably use $4 for the first year and $5-$7 for the years following.
Permalink Reply by The_Baron on April 21, 2009 at 7:12
Don't forget to account for severance taxes.
Permalink Reply by b on April 21, 2009 at 8:09
is that per acre
Permalink Reply by Jon Williamson on April 21, 2009 at 8:43
yup
Permalink Reply by JeffNParis on April 21, 2009 at 9:15
Jon,
What do these figures mean if they put more than one well on the property. Would the figures be the same for each well? Spacing is figured at 60 acres per well? So if there were 3 wells it'd be three times the amount? Or just that amount for the entire acreage?
Jeff
Permalink Reply by Jon Williamson on April 21, 2009 at 9:39
Jeff those figures would be for just one well. If you were in a productive area you would likely get 4-8 wells per section. It's always best to be conservative though, when placing a value on an interest.
Permalink Reply by JeffNParis on April 21, 2009 at 9:45
Ok...thanks. One more question Jon. If you're part of a 640 acre section, do you get paid for each well producing in that section? Thanks for all your help...it is disappointing to see the decline rate but I guess you take the bad with the good!
Permalink Reply by The_Baron on April 22, 2009 at 2:57
YOu get paid for each well in your unit. Most units are on section lines, but not all.
Permalink Reply by lanadan Ds3 on April 21, 2009 at 22:31
Jeff,

Go to: www.haynesvilleplay.com/2009/03/decline-curves.html

Click on the decline curve graph for larger size. Goodrich Petroleum shows 3 models, with 7.0, 10.0, and 13.0 MMcf/d of IP (unitial production) wells.

This is right in line with other "guestimates" that I have seen.
Permalink Reply by Skip Peel - Mineral Consultant on April 22, 2009 at 2:13
Goodrich is using Chesapeake's decline curve graph. The two are identical.
Permalink Reply by alleyboy on April 22, 2009 at 2:52
Seems like the royalty a small tract(1/2 acre) owner will get over time will be very small.

RSS

Support GoHaynesvilleShale.com

Top Content 

1 Comstock October Presentation

Comstock October Presentation
2 Looking Back At The Haynesville Shale - A Retrospective

Looking Back At The Haynesville Shale - A Retrospective
3 Pending Public Oil and Gas Hearings

Pending Public Oil and Gas Hearings
4 Arkansas O&G Commission unanimously denies royalty rate application for lithium extraction

Arkansas O&G Commission unanimously denies royalty rate application for lithium extraction
5 Authority for Expenditure

Authority for Expenditure
6 Alarm Bells Are Ringing

Alarm Bells Are Ringing
7 Unleased Mineral Interest

Unleased Mineral Interest
8 Arkansas Smackover Lithium Play

Arkansas Smackover Lithium Play
9 For Erica Woodward

For Erica Woodward
10 Permian Associated Gas Will Depress Haynesville Gas Prices Long Term

Permian Associated Gas Will Depress Haynesville Gas Prices Long Term

Not a member? Get our email.

Groups



© 2024   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service