Replies to This Discussion

Permalink Reply by DJG on May 1, 2010 at 2:43

Sonerra Resources Corp / Shooting Star #1
15 miles SE of Nacogdoches
JM Mora Survey / A-827

http://webapps.rrc.state.tx.us/DP/drillDownQueryAction.do?fromPubli...

Permalink Reply by DJG on May 1, 2010 at 2:45

Sonerra Resources / Sky Racer #1
10 miles SE of Nacogdoches
JM Mora Survey / A-827

http://webapps.rrc.state.tx.us/DP/drillDownQueryAction.do?fromPubli...

Permalink Reply by DJG on May 1, 2010 at 2:46

EOG / ACLCO Unit 1-H
3.1 Miles SW of Chireno

JA Chireno Survey / A-17

http://webapps.rrc.state.tx.us/DP/drillDownQueryAction.do?fromPubli...

Permalink Reply by DJG on May 1, 2010 at 2:47

EOG / Atkinson Unit 1-H
2.4 Miles SE of Chireno
JA Chireno Survey / A-17

http://webapps.rrc.state.tx.us/DP/drillDownQueryAction.do?fromPubli...

Permalink Reply by DJG on May 1, 2010 at 2:48

EOG / Leinart Unit 1-H
12.4 Miles SE of Nacogdoches

JM Mora Survey / A-17

http://webapps.rrc.state.tx.us/DP/drillDownQueryAction.do?fromPubli...

Permalink Reply by RBH on May 3, 2010 at 3:40

New Permit EOG/ Trainer Trust #1H offset to Crane #1H

Permalink Reply by reallyoldguy on May 3, 2010 at 3:48

RBH: thanks for the info. Is the Trainer Trust #1H in the Chireno or the Totin survey?

Permalink Reply by jffree1 on May 3, 2010 at 4:06

Chireno, A-17

Permalink Reply by RBH on May 3, 2010 at 8:28

reallyoldguy--Trainer Trust #1H in chrireno 17-just bordering the Totin Survey

Permalink Reply by jffree1 on May 2, 2010 at 5:41

Nacogdoches County

The Barton Well No. 2H is located 6.6 miles south to Martinsville. Devon Energy Production Company L.P. has completed this well to a depth of 12,265 feet in the Carthage Field. When gauged on an adjustable choke, the well potentialed 6,700 feet (?). Production is in Haynesville Shale formation.

This report was found in the Nacogdoches Daily Sentinel (but not in the Tyler Morning Telegraph... go figure):

http://dailysentinel.com/news/business/article_3740fe5c-556a-11df-b...

Permalink Reply by adubu on May 2, 2010 at 11:28

jffreel1 ---must be typo and ? should be 6,700 mcfd or 6.7 mmcfd would make sense. If I can remember I'll call RRC in Kilgore tomorrow. A marginal well for H shale to give ROI for Devon. Maybe they had it choked back.

Permalink Reply by jffree1 on May 2, 2010 at 12:44

The question mark was mine... but that's the way it was put in the paper. I would assume 6.7 MMcfd and Devon never tells choke size so anything you can find out would be appreciated. I do hope it is choked back. However, XTO had the Rudy Mitchell #1H way up in the NW corner of San Augustine that had IP of 5.6 MMcfd on 48/64 choke. Could be apples and oranges without looking at the lateral length and frac stages, though.

• ‹ Previous
• 1
• …
• 8
• 9
• 10
• 11
• 12
• …
• 14
• Next ›
• Page