Replies to This Discussion

Oil & Gas ProPermalink Reply by Two Dogs, Pirate on February 15, 2011 at 14:54

May have something to do with the lignite mine?

• ▶ Reply

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on February 15, 2011 at 14:55

These are the permitted depths.  The actual depths will be entered in the SONRIS Lite Well File at a later date.

• ▶ Reply

Permalink Reply by buckmaster on February 15, 2011 at 15:08

Skip they started drilling the well on 1/5/11 it is going to be a north to south lateral so it should take the mine out of play.

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on February 15, 2011 at 15:22

Buck, this well looks similar to many others I have seen so not that unusual.  Also, realize there is no way to know the true lateral length from the referenced information.

• ▶ Reply

Permalink Reply by buckmaster on February 15, 2011 at 15:47

I had not noticed  any that long  and was wondering what might be up. will wait for some more well info. thanks to you and Skip for info

• ▶ Reply

landownerPermalink Reply by Henry on February 16, 2011 at 0:18

This well looked (to me, at least) a bit unusual, in that the surface location was something like 1000' (if I remember) from the north line of the section.  The maps show the drill bore going northward toward the section line, and then turning more than 90 degrees back southward to get the lateral to run all the way to the south line.

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on February 16, 2011 at 3:50

Henry, several companies are using this approach to maximize the length of the horizontal lateral.

• ▶ Reply