Replies to This Discussion

landownerPermalink Reply by kittycatmama on August 5, 2010 at 14:52

what does this mean: flowing over 700 on pressure?

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on August 5, 2010 at 15:33

Mac, the well has a flowing casing pressure of 7964 psi at the wellhead upstream of the choke.

Most Haynesville Shale wells are initially tested before production is installed so that is the reason for the flowing casing pressure rather the more typical flowing tubing pressure. Production tubing would be installed 2-3 months later after the water production rate has declined.

• ▶ Reply

landownerPermalink Reply by Mac Davis on August 6, 2010 at 16:20

OK, the well in question lists 1034, 758, 512 as the casing size. I'm assuming this means that the "hole" size tapers as you go further down the well. If I'm correct and the hole is 10.34 inches at the top, that's 668,000 lbs or 300 tons.

YOW!!! That's the weight of 1 1/2 modern locomotives.

I'd hate to be the guy who has to put the cap back on if it comes unscrewed.

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on August 6, 2010 at 16:28

Mac, you are close on casing diameters:

10 & 3/4"
7 & 5/8"
5 & 1/2"

• ▶ Reply

landownerPermalink Reply by Mac Davis on August 7, 2010 at 4:08

Thanks, Les. I was thinking 10 3/4, but typed 10.34.

• ▶ Reply