what does this mean

1. SET CIBP @ 15,473' MD IN THE 7- 5/8" LINER 2. BAIL 12' OF 16.0 PPG CEMENT ON TOP OF THE 7 - 5/8" CIBP 3. SET CIBP @ 5,999' MD IN THE 9 - 5/8" CASING 4. SET AND LOCK DOWN TEST PLUG IN WELLHEAD -THESE PLUGS MAY NEED TO BE DRILLED OUT FOR PROPER P&A

Views: 47

▶ Reply to This

Replies to This Discussion


Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant 2 hours ago

Set cement bridge plug @ 15,473' Measured Depth in the 7 - 5/8" Liner.  Bail 12' of 16 Pounds Per Gallon cement on top of the 7 - 5/8" Cement Bridge Plug @ 5,999' Measured Depth in the 0 - 5/8" casing.  Set and Lock down test plug in well head.

This looks like a temporary P&A but without identifying the specific well, it is impossible to say.  If the well will be eventually Plugged & Abandoned, these plugs would have to be drilled out and replaced with proper plugs and casing cement that meet state requirements.  This appears to be a test well.


landownerPermalink Reply by Dale Walton 2 hours ago

If you post the SN or another form of ID I can help you.  

Permalink Reply by lee 2 hours ago

S# 255786


Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant 2 hours ago

landownerPermalink Reply by Dale Walton 2 hours ago

It is a pilot hole for the Haynesville/Bossier.  Rumor is that the well experienced higher than normal bottom hole temps and they decided to move off location and pause.  Maybe we wait for the 3D data before going HZ.  

RSS

© 2026   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service