Replies to This Discussion

Permalink Reply by Stan Grimm on February 3, 2010 at 6:28

I see on the Arkansas Oil and Gas Commission map that Seeco has a spud well in the new Ozark Highlands Unit. It is located in section 12, T 10N, R 17 W in Van Buren County. Permit no. 42951. Is anyone aware of any other wells that have been drilled in the Ozark Highlands Unit?

Permalink Reply by john goodday on February 14, 2010 at 7:41

According to the AOGC weekly scout report - this has been the only well permitted, drilled or completed in the Ozark Highlands Unit. I keep a very watchful eye on this area and it will be interesting to see how
SEECO plans to develop. Will keep you posted!

Permalink Reply by Stan Grimm on February 15, 2010 at 4:25

John, Thanks for the information. I am not familiar with the AOGC weekly scout report. How does one access it? Thanks for your help. Stan

Permalink Reply by john goodday on February 15, 2010 at 6:00

Stan,

Google AOGC.com (Arkansas Oil & Gas Commission) and you will see where they have a "Current Permit / Completion Report". I refer to it as the weekly scout report. Let me know if you need further help.

Permalink Reply by Stan Grimm on February 15, 2010 at 7:52

John, thanks to you, I found the report. Will also check it regularly. Have a good week. Stan

Permalink Reply by john goodday on February 15, 2010 at 10:03

In regards to the Ozark Highlands area, we'll have to monitor the regularly scheduled monthly "hearings" (AOGC) to see how SEECO proposes to share production - participation units.

Thanks

Permalink Reply by Stan Grimm on February 16, 2010 at 13:52

Thanks again and I agree we need to keep a close watch.

Permalink Reply by George Lutz on June 4, 2010 at 13:30

Can someone help me understand this flow rate? I thought that a typical Fayettevile shale play flow rate was between .5 and 2.0 million cu ft per day. 8 million is huge! It this a matter of more effective fracing or are my estimates completely wrong?

George Lutz

Permalink Reply by whodat on October 16, 2012 at 4:22

I have tested many wells there in the Fayettville from my experience most wells after they clean up flow around 2.0mcf per day. The shale seems to be consistent throughout. Every now and then we would see wells test up to 11.mcfd (11.mcfd was near Morrilton) so its not uncommon for a barn burner to be in the middle of other average wells.

Permalink Reply by john goodday on November 28, 2012 at 2:52

Would you know how many wells are currently in operation by Seeco, BHP, XTO.  How about north of Greers Ferry Lake in Cleburne County - what type of activity is currently happening?

 

Permalink Reply by Bradley McWilliams on February 1, 2013 at 16:33

I don't know the well count, but the web sites of these may help.  SWN has by far the largest amount.  I would guess that they have half the total, and the other half divided up between XTO and BHP. (BTW- anybody else ever notice that the three companies up here all go by three initials???)

As far as north of the lake, There are a few wells up there, but it isn't as dense as south of the lake.  I don't know if it's because it isn't as good, or just not focused on the area yet.  It's not as though it's been left behind, it's just not as busy.

Permalink Reply by Skip Peel - Mineral Consultant on February 5, 2013 at 4:03

A lot of companies go by their 1 to 4 letter stock symbols.  SWN and BHP for example.  XTO is now a division of XOM but still goes by its old stock symbol.

• ‹ Previous
• 1
• 2
• Next ›
• Page