Replies to This Discussion

Permalink Reply by George Walsh on June 20, 2013 at 10:39

This location are the two sections southeast of the Crosby well. I heard they are working night and day to get the pad ready. There is another permit before the MSOGB for the two sections northwest of the Crosby well. Things really heating up near the Crosby well.

Permalink Reply by Bernell McGehee on June 20, 2013 at 11:20

The new well you're talking about George must be the Calvin 11-2H-1.

I saw it on the docket, but didn't try to figure out where it was located.

Permalink Reply by Charles Bell on June 20, 2013 at 12:31

I have the Calvin well at Sect 2,11 T2N R1W. No coordinates other than that.

CBell

Permalink Reply by Steve on June 24, 2013 at 15:54

Any updated production numbers reported yet on either Ash well?

Last I heard was around 400 bopd on Ash 2 on artificial lift (pump). Water /Oil ratio?

Is the pump Ash 1 on a working pump yet ?

I hope Encana will soon go back in and try again to clear the remaining coil tubing to get this well working to potential.

Encana isn't talking about these Ash wells much - not a good sign. I expect them to go back to less proppant on the 2 Anderson wells which are now being fracked - more of a Goodrich Crosby well style completion, adding a clay stabilizer like Goodrich did on the Crosby. IMO

Permalink Reply by Bernell McGehee on June 24, 2013 at 17:33

Encana hasn't said much about the 2 Weyerhauser wells, either, although the stated in their last quarterly report that they would be giving updates during the quarter...next quarterly report is set for mid July.
It is no wonder their stock is floundering.

Permalink Reply by Andrew on June 24, 2013 at 18:27

None of those 4 wells seem like ones Encana would want to draw attention to.

Permalink Reply by Steve on June 25, 2013 at 0:57

The only positive news for the TMS is that the issues with these 4 Encana wells are more completion related foul ups not formation related. IMO

Permalink Reply by onesock73 on August 1, 2013 at 7:53

Any more on the status of these wells?

Permalink Reply by MACAULAY on August 1, 2013 at 8:10

Ash 1, with the trouble in the hole made in May, the first full month of production, only 1445 barrels.

Ash 2 made in same period, also its first month, 12,319 barrels. 

Decline rate for others has been 50 percent in the first 3 months.

Permalink Reply by onesock73 on August 1, 2013 at 10:41

Ouch!

Permalink Reply by Steve on August 1, 2013 at 14:13

Pumped too much water in 1st well to get a good daily rate. Still has coil tubing stuck in the other well. Next wells in this unit will be much better. IMO

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page