Replies to This Discussion

landownerPermalink Reply by Linda Blunt on February 17, 2010 at 4:21

Les,
Are these pads 5 or more acres?

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on February 17, 2010 at 5:07

Linda, that is my understanding. The pads should also provide the room for any production equipment (separators, tanks, etc).

• ▶ Reply

landownerPermalink Reply by Linda Blunt on February 17, 2010 at 5:10

Thank you very much for the explanation! :)

• ▶ Reply

landownerPermalink Reply by Spring Branch,mineral owner on February 18, 2010 at 0:00

I have been on many of these pads. They are typically 10-12 acres in size.

• ▶ Reply

landownerPermalink Reply by Linda Blunt on February 18, 2010 at 2:35

Thank you SB,
Beusa has put a large pad on one of our sections. I was told that it is a five acre pad. Thanks again!

• ▶ Reply

landownerPermalink Reply by Spring Branch,mineral owner on February 18, 2010 at 8:22

That would be a normal single well pad. Certainly not a double pad. I probably should call it a normal, single section pad.

• ▶ Reply

landownerPermalink Reply by Linda Blunt on February 18, 2010 at 8:39

Thank you,

landownerPermalink Reply by R B on February 17, 2010 at 5:41

Hello Les-Is this what Encana refers to in their latest presentation as a "gas factory"? Thanks again for all the helpful insight.
R B

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on February 17, 2010 at 7:06

RB, yes- I would definitely interpret EnCana's "gas factory" to be a reference to a pad drilling development mode. Of course I like to give that term a bit more spin.

"Haynesville Shale - Gas Factory"

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on February 16, 2010 at 12:16

LI, no - T14N-R12W was included.

• ▶ Reply

Permalink Reply by James Collella on February 16, 2010 at 16:17

I am pleased with the good old CV production. Less drama and good steady checks. It is time the steam started to leak out of the HS Blowhards.

• ▶ Reply

landownerPermalink Reply by Spring Branch,mineral owner on February 16, 2010 at 17:04

The Haynesville Shale does not preclude the Operators from drilling Cotton Valley wells. Personally, I like the idea of receiving royalty checks from a Haynesville well that will make 3 Billion cu ft of gas in it's first year rather than a Cotton Valley well that won't make 3 Billion cu ft in it's lifetime. Tell me what Section, Township and Range you're in and I'll gladly have my attorney work up the paperwork for a swap, if you're in the play, James C. My Cotton Valley for your Bossier/Haynesville....acre for acre....even. If you're not in the Haynesville play, then I know why you're satisfied with the Cotton Valley.....I would be too. Personally, I'd like to have Cotton Valley, Bossier and Haynesville production from my minerals at the same time. How sweet would that be!

• ▶ Reply

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page