landowner

Haynesville Production Decline vs. Royalty Calculator Estimates

Shalers,

I hear that Haynesville wells are supposed to decline a great bit after the first year...but have wells been in production long enough to prove this?

When I go to natural gas royalty calculators on the internet they don't make provision for such steep declines, and I suppose the reason for not doing so is that they are set on 'average well decline'. Is there a place to go to estimate royalties from the Haynesville?

Thanks,
Jeff in Belgium

Views: 296

▶ Reply to This

Replies to This Discussion

Permalink Reply by Jon Williamson on April 21, 2009 at 7:09
Now that I think about it. I would probably use $4 for the first year and $5-$7 for the years following.

Oil & Gas ProPermalink Reply by The_Baron on April 21, 2009 at 7:12
Don't forget to account for severance taxes.
Permalink Reply by b on April 21, 2009 at 8:09
is that per acre
Permalink Reply by Jon Williamson on April 21, 2009 at 8:43
yup

landownerPermalink Reply by JeffNParis on April 21, 2009 at 9:15
Jon,
What do these figures mean if they put more than one well on the property. Would the figures be the same for each well? Spacing is figured at 60 acres per well? So if there were 3 wells it'd be three times the amount? Or just that amount for the entire acreage?
Jeff
Permalink Reply by Jon Williamson on April 21, 2009 at 9:39
Jeff those figures would be for just one well. If you were in a productive area you would likely get 4-8 wells per section. It's always best to be conservative though, when placing a value on an interest.

landownerPermalink Reply by JeffNParis on April 21, 2009 at 9:45
Ok...thanks. One more question Jon. If you're part of a 640 acre section, do you get paid for each well producing in that section? Thanks for all your help...it is disappointing to see the decline rate but I guess you take the bad with the good!

Oil & Gas ProPermalink Reply by The_Baron on April 22, 2009 at 2:57
YOu get paid for each well in your unit. Most units are on section lines, but not all.

landownerPermalink Reply by lanadan Ds3 on April 21, 2009 at 22:31
Jeff,

Go to: www.haynesvilleplay.com/2009/03/decline-curves.html

Click on the decline curve graph for larger size. Goodrich Petroleum shows 3 models, with 7.0, 10.0, and 13.0 MMcf/d of IP (unitial production) wells.

This is right in line with other "guestimates" that I have seen.

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on April 22, 2009 at 2:13
Goodrich is using Chesapeake's decline curve graph. The two are identical.

landownerPermalink Reply by alleyboy on April 22, 2009 at 2:52
Seems like the royalty a small tract(1/2 acre) owner will get over time will be very small.

RSS

📧 Want email updates on new discussions?
Click Forum and scroll down past the last discussion and click the "Follow" button.

Top Content 

1 Haynesville Deep Phase 1 3D Seismic map

Haynesville Deep Phase 1 3D Seismic map
2 More Natural Gas for the Gulf Coast Market with Low Breakeven costs

More Natural Gas for the Gulf Coast Market with Low Breakeven costs
3 Standard Lithium vs GeoFrame vs T5

Standard Lithium vs GeoFrame vs T5
4 Billion dollar changes in the Haynesville Shale, energy prices expected to stay high

Billion dollar changes in the Haynesville Shale, energy prices expected to stay high
5 Rockcliff III Counters Haynesville Inventory Concerns with Shelby Trough Push

Rockcliff III Counters Haynesville Inventory Concerns with Shelby Trough Push
6 Request For Assistance

Request For Assistance
7 The Curious Case of SAMSON CONTOUR

The Curious Case of SAMSON CONTOUR

Groups

© 2026   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service