Replies to This Discussion

Oil & Gas ProPermalink Reply by Les Bamburg on July 18, 2010 at 14:10

PG, its is not technically feasible to refrac a multi-stage frac'ed horizontal Haynesville Shale well.

Re-frac's were utilized for a few vertical Barnett Shale wells.

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on July 18, 2010 at 14:08

John, I have seen at least two Louisiana Haynesville Shale wells with 20 frac stages. Most Haynesville Shale wells in Lousiana cannot exceed 4620 ft due to the spacing rules (5280 - 2 * 330).

• ▶ Reply

landownerPermalink Reply by JeffNParis on January 12, 2011 at 4:18

What exactly is a 'frac stage'?

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on January 12, 2011 at 11:32

JNP, the Haynesville Shale wells are completed with multiple separate hydraulic fracture treatments and each separate treatment is referred to as a frac stage.  Each frac stage will be separated by a casing plug.  These plugs are drilled out when the well is ready to be brought on production.    

• ▶ Reply

landownerPermalink Reply by JeffNParis on January 12, 2011 at 12:27

Thanks Les B. You're a wealth of knowledge.

• ▶ Reply

landownerPermalink Reply by Missy on January 12, 2011 at 14:30

Les, If a well is 'flowing back' does that mean that the frac process is complete? 

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on January 12, 2011 at 16:13

Missy, yes - that should be correct.  Fracing completed, drilled out plugs, flowing back, turn to sales ($$$$).

• ▶ Reply

landownerPermalink Reply by w.r. frank on July 18, 2010 at 14:41

Brasch Family 3H, #239,839, S3, 13N, 13W, has 23 frac stages. CHK well at 22+ mmcfd IP.

• ▶ Reply

Permalink Reply by Chad E Ellis on July 18, 2010 at 15:40

The Chad Ellis 2H (Samson Lonestar in Harrison County, Texas) was just completed with a 6232' lateral and 20 frac stages. The well IP'd at 10.4MMCF with 8000lbs of downhole pressure on a 22/64 choke. Samson was unable to open choke further due to pipeline constraints.

• ▶ Reply

landownerPermalink Reply by ledlights on July 19, 2010 at 5:23

Nothing like reporting a nice well with your name on it. Or is that some other Ellis family?

• ▶ Reply

Permalink Reply by Chad E Ellis on July 19, 2010 at 10:43

No, it's mine. I'm glad that Sampson appears to be using the HK model. They're not pulling it hard and the flow rates and pressures have remained steady over the 1st month of production. As a note, the well was permited for a 6800' lateral but is producing from 6232'.

• ▶ Reply

• ‹ Previous
• 1
• 2
• Next ›
• Page