landowner

Plugback

What does plugback refer to on the Sonris site?

Views: 114

▶ Reply to This

Replies to This Discussion


Oil & Gas ProPermalink Reply by The_Baron on August 19, 2010 at 5:56
You can expext several months to go by after completion. It doesn't appear the well you have refered to has been fraced yet.

landownerPermalink Reply by FXEF on October 19, 2010 at 13:19
smith1,

It appears that there may have been problems with the well. SONRIS reports 16885' MD and set 5 1/2 casing to 15075'. They have lost 1810' of lateral for some reason.

landownerPermalink Reply by smith1 on April 4, 2011 at 8:42
wondering if any update for this well #239994, still have not received any division orders either.

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on April 4, 2011 at 9:00
It's probably a little early for a DO.  The well was tested on Jan. 18.  14.064 MMcfd on a 22/64" Choke with 7330# Flowing Pressure.  If you haven't heard anything by the end of the month, give Chesapeake a call.

landownerPermalink Reply by smith1 on April 4, 2011 at 9:49
I will and thanks. BTW, did you find this info on Sonris? I tried looking earlier

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on April 4, 2011 at 10:47
Yes, SONRIS Lite.  It's not under the Well Scout section.  Look a little further down at the Well Test section.

landownerPermalink Reply by smith1 on April 5, 2011 at 4:46

Thanks, found it but what does the DEL mean? Delivery?

RPT TYP

TEST DATE

RPT DATE

GAS DEL

SDM2G

01/19/2011

01/19/2011

14064

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on April 5, 2011 at 7:22
Gas Delivered

landownerPermalink Reply by Joe Aldridge on April 4, 2011 at 12:17
My understanding of "Plug-back" is that they did not find anything in the lower section of the hole and they simply plugged back to the section that had what they were looking for in it. There is no need to leave open hole or case a hole any distance below the production formation.

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on April 4, 2011 at 12:26
In HA horizontal wells, plug backs are common.  The vertical is utilized to log the HA and determine the target depth for the horizontal.  Then the operator plugs back to a shallower depth to kick off the lateral.

RSS

© 2026   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service