Replies to This Discussion

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on December 7, 2010 at 13:04

The state database organizes well files by surface location and section. Since a horizontal well may have a surface location in one section but the lateral perforations in an adjoining section, you need to check the PBHL (Planned Bottom Hole Location). In this case the well surface location is in Section 22 but the lateral perforations in Section 15. The TD date is likely a typo and should read 10-25-10.

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on December 7, 2010 at 13:04

KCM, it can happen as Chesapeake has taken over as operator from Camterra. It has also happened a few times between Shell and EnCana.

The TD date is a typo and was probably supposed to be 10/22/10.

• ▶ Reply

landownerPermalink Reply by kittycatmama on December 7, 2010 at 15:43

Skip, Les, thanks to both for the info. I had not seen anything like this on Sonris before so was confused.

• ▶ Reply