landowner

Haynesville Shale Unit Size

Where can I find the size of a haynesville unit in Louisiana.  I know most haynesville shale units are sectional, but does the operator disclose the number of acres in the unit?  Since the number of acres in a section vary, I figured unit size will vary also.

 

Thanks.

 

Mike (still without a clue)

 

Tags: Haynesville, Shale, Size, Unit

Views: 231

▶ Reply to This

Replies to This Discussion


Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on March 8, 2010 at 14:38
There is no standard size in acres for a HA Drilling & Production Unit although most are a governmental section. And standard sections do vary slightly in total acres. If you wish to know the exact acreage of a specific drilling unit, you have to look it up in the application.

http://dnr.louisiana.gov/cons/CONSEREN/hearings/pubhearings2010.htm

landownerPermalink Reply by Spring Branch,mineral owner on March 8, 2010 at 23:04
From my experience , the application is not always exact as to specific acreage in a unit.

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on March 9, 2010 at 3:25
SB is correct as "in exact to the fraction of an acre". However unit applications contain a total acre figure that is "+/-" and usually close enough for mineral owners to figure their percentage of mineral acres in the unit.

landownerPermalink Reply by Mike Tomlin on June 4, 2010 at 3:19
Thank you for responding.

Is there a way to view unit applications from wells drilled in the 1950s and 1960s?

Thanks.

Oil & Gas ProPermalink Reply by The_Baron on June 4, 2010 at 5:11
no, but you can view the unit orders. all unit orders are available on SONRIS.

landownerPermalink Reply by Mike Tomlin on June 4, 2010 at 5:24
Thank you.

Unfortunatley, the unit orders doesn't have the size of the units.

landownerPermalink Reply by Mac Davis on June 4, 2010 at 7:21
Does the unit order at least specify that it's a full township/range/section? Is there a map as part of the unit order?

Oil & Gas ProPermalink Reply by The_Baron on June 4, 2010 at 7:28
most unit orders will have a map. There will always be some description, otherwise how would we know what the unit ecompassed?

Oil & Gas ProPermalink Reply by The_Baron on June 4, 2010 at 7:30
Yes, the unit orders always have a approximate size. The true size is determined when a full survey is made for a division order.

For units that are based on section lines (or 1/4 section or whatever...geographic units..) the actual size can be found by looking at the original PLS maps.

Oil & Gas ProPermalink Reply by The_Baron on June 4, 2010 at 7:37
look at this example, the maps clearly show the approximate unit size.
Attachments:

landownerPermalink Reply by Mike Tomlin on June 4, 2010 at 8:28
Thank you for your response.

I looked at over 12 unit orders today that did not have approximate acreage. I was probably looking at the wrong orders or something. I will keep digging and will hopefully come up with what I am looking for.

Thanks again.

Oil & Gas ProPermalink Reply by The_Baron on June 4, 2010 at 8:54
give me a refernce #....

RSS

© 2026   Created by Keith Mauck (Site Publisher).   Powered by

Badges  |  Report an Issue  |  Terms of Service