Replies to This Discussion

Permalink Reply by Skip Peel - Mineral Consultant on February 3, 2015 at 8:50

Unless there was a mechanical problem with the well, that's not sufficient production to justify drilling any further wells in that location.

Permalink Reply by Jim Bemis on February 3, 2015 at 16:04

My fingers are still crossed,skip. Thanks for your info.

Permalink Reply by Jim Bemis on March 9, 2015 at 5:26

Hi all,
Anybody have more recent info on the Morris well. I haven't been able to get a completion report or other info relating to Anadarko's
abbreviated division order,either from Texas RRC or Anadarko. However I have now received a second check. Nice folks at Anadarko but not very informative. Some mention of a possible second well.

Jim Bemis

Permalink Reply by waylon buckland on March 11, 2015 at 13:35

JIM WHAT SIZE IS THE UNIT AND HOW CAN I GET A COPY

Permalink Reply by Jim Bemis on March 11, 2015 at 16:25

Waylon -

The abbreviated divishon order doesn't provide much information beyond that on Skp's initial post for the Morris E R 1H, James Taylor Survey  Abstract 1029.

As I recall, the orgiinal Petro-Land  lease had a 640 acre unit size, and the total  orginal Petro-Land lease (now Anadarko) was for around 1700+a acres.  I own only a small sliver, but most of he James Taylor Survey has been been leased several times, with dwindling production  over the past 50 or 60 years.-- before refracking, horizontal wells, and all the new technologies.

However, I figure the old piplelines and other infrastructure  must have already been in place, because the Morris well  started production so quickly after the permit was assigned. However, Anadarko's division order was very minimal, which, for me, made it dfficult to gain specific information.

You and the Forum  have done a great job  of keeping  us updated, but like Skip has posted, the RRC doesn't have very strong requirements for operators to submit  their completion and production  reports.

I'm very much a novice in thcurrent oil and gas game, and I'm not up to speed on the new RRC site. So I guess it's still "wait and see" for the most recent  production data.

(I also have a small interest in some of the  old Rodessa pooled units very close by to the Morris well,  but I  don't understand how they might  fit in somehow.)

Thanks again,

Jim  Bemis

Permalink Reply by waylon buckland on March 14, 2015 at 12:55

jim how can you determine that your royalty interest is correct if you dont know the size of the unit?

Permalink Reply by Jim Bemis on March 14, 2015 at 14:23

Waylon --

I'm not clear what you mean by unit size?

Permalink Reply by jffree1 on March 16, 2015 at 5:09

Jim,

All of the completion paperwork turned in by Anadarko on the Morris well is available at this link (no production reports on this page):

Completion Packet

Waylon,

Unit plat is attached.

Attachments:

• Morris, E R #1H.jpg, 2.5 MB

Permalink Reply by Jim Bemis on March 20, 2015 at 10:45

Waylon & jjfree1,
Thanks.I thought I sent a reply earlier but I guess it didn't stick. From where I sit, we don't yet have much more useful info, but I figure they have a ton of questions themsselves.

Thanks again
JIM

Permalink Reply by jffree1 on March 20, 2015 at 12:59

Anadarko moved a rig out of Panola Co. last week so I'll be looking for it to turn up in a new location. They could have just ended a contract, though, so it may not reappear in East Texas.

Permalink Reply by Dats Oil Brother on March 25, 2015 at 11:51

Can't get confirmation yet but hearing that the well averaged 385 boe toward the end of testing before being shut down. No word on when it would be producing or plans for next well.

Permalink Reply by Waylon Buckland on May 7, 2015 at 13:12

the bare creek well is shut in with 2000 l pounds of presure its gonna be a good one when they sand frack it

• ‹ Previous
• 1
• 2
• 3
• 4
• 5
• Next ›
• Page