Replies to This Discussion

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on July 20, 2011 at 4:12

Robert, you will get quicker response when asking location specific questions when you post in the correct group.  Here are links:

 

http://www.gohaynesvilleshale.com/group/sanaugustine

 

http://www.gohaynesvilleshale.com/group/shelbycounty

• ▶ Reply

Permalink Reply by jffree1 on July 20, 2011 at 4:50

Robert, where did you find that information, please?  I suspect that it is out of date.

Chesapeake has finished drilling the Hatch GU SAG #1H, B. B. Pickard Survey, A-493, in San Augustine County, and Trinidad rig 107 just spud the Durham GU SLB #1H, John Buckley Survey, A-41, in Shelby County, on 7-14-11.

• ▶ Reply

landownerPermalink Reply by Robert Garsee on July 20, 2011 at 7:11

 

 I live not a 1/4 mile from it. It is in the John Buckley Survey A-41. I got the information on this web-site and it says San Augustine. I live in Shelby and so is that rig. I am just trying to find out if I am in the pool as that is the survey I am in.

Thanks

Robert

• ▶ Reply

landownerPermalink Reply by FXEF on July 20, 2011 at 7:32

Robert,

Here is a plat of the Durham GU SLB #1H unit with all the pooled interest listed.

 

Attachments:

• PR0001139790_0001.jpg, 826 KB

• ▶ Reply

landownerPermalink Reply by Robert Garsee on July 20, 2011 at 7:50

 

 Thanks FXEF,

Not exactly sure, but I thin k I am a little bit southeast of there. Any way to get a plat of my place for future use?

Robert

• ▶ Reply

Permalink Reply by jffree1 on July 20, 2011 at 8:31

Robert, you can call the appraisal district and ask them for a tract level shot of their map.  If you own the surface, or know who does or can otherwise locate the tract on the ground, they should be able to pull it up on the computer and print a copy.  If you are in the county it may be easier to just go see them because there is usually a small fee required.

• ▶ Reply

landownerPermalink Reply by Robert Garsee on July 20, 2011 at 8:34

 

 Thanks jffree

• ▶ Reply

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on July 28, 2011 at 3:36

When the drill bit first touches the earth,  the well is said to be "spud".  Spud date is first day of actual drilling operations.

• ▶ Reply

landownerPermalink Reply by Robert Garsee on July 28, 2011 at 3:41

 

 Anyway to get the information on a well in progress.

• ▶ Reply

landownerPermalink Reply by obed w odom on July 28, 2011 at 7:03

Not to put too fine a point on it, but aren't the past tense and past participle of spud written as "spudded". At least this is the way I have always seen it before.

• ▶ Reply

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on July 28, 2011 at 7:55

obed, that's too fine a point.  LOL!  But you are correct.

• ▶ Reply