Replies to This Discussion

Permalink Reply by David Crockett on October 31, 2019 at 6:02

What exactly does this mean?  They haven’t gone any deeper in a week. 

Permalink Reply by Rock Man on October 31, 2019 at 8:52

Could be indicating that they used smaller and less expensive rig for this part of the hole. And that they have now released that rig and are waiting on larger rig to continue drilling. Very common practice in today's Hz drilling world.

Permalink Reply by David Crockett on October 31, 2019 at 11:25

Okay. Thanks Rockman!

Permalink Reply by Lisa Melder-Johnson on November 12, 2019 at 4:59

ANOTHER UPDATE on 11/11/19 "RIH W/FREE POINT; SEVERED PIPE @ 14754'; TOOH; TSST BOP'S 11/7/19 (ANNULAR: SCHAFFER, 13.5/8", 5000; RAMS: CAMERON TYPE U 13-5/8", 5-1/2" & VBR, 10000); MAKE WIPER TRIP TO CLEAN HOLE TO 14754'; LOG INTERMEDIATE F/14654' TO CSG SHOE; CURRENTLY RIH TO CONDITION TO RUN 9-5/8" CSG."

Permalink Reply by Rock Man on November 12, 2019 at 5:39

Thanks for posting this. Operations clearly discuss cutting off lost/ stuck pipe, cleaning up wellbore, getting logs and prepping to run casing. Expect next report to be completion of casing run and prepping to pick up drilling tools.

Permalink Reply by Lisa Melder-Johnson on November 12, 2019 at 7:01

So are they walking away from this one or are they going to move over & try again on the same pad just like they did with Crowell #1 to Crowell #2 251809.   Wasn't this the well that the ENSIGN 777 was going to or was it another one?

Permalink Reply by Rock Man on November 12, 2019 at 7:39

No, they are doing all this work to allow them to continue drilling in this well. They will sidetrack around the abandoned part of the hole with the junk / stuck drill pipe et al after setting the 9.625" casing

Permalink Reply by Lisa Melder-Johnson on November 12, 2019 at 9:42

Good to hear!

Permalink Reply by David Crockett on November 14, 2019 at 14:43

Work permit application for this well dated 11/13/2019: sidetrack: set a cased hole whipstock inside 9 5/8” csg, , mill out window, drill curve and td the Austin chalk lateral.  The proposed setting depth of the cased hole whipstock is 14690’, depending on the final csg tally. 

Permalink Reply by Lisa Melder-Johnson on November 15, 2019 at 4:03

Good deal!   Looks like they are still working on it.   I know on Kirk's Blog this was a difficult drilling area too.

Permalink Reply by David Crockett on November 22, 2019 at 7:51

I see that there is s permit for these guys a saltwater disposal well

Permalink Reply by Hydrocarbonite on November 26, 2019 at 3:16

11/25/2019

05

14747

TIH TO 14692' W/BIT & SCRAPER FOR CLEAN UP RUN; RIN W/WHIPSTOCK; SET WHIPSTOCK @ 14692'; MILL WIBDOW; CURRENTLY DRLING CURVE @ 14718'.

• ‹ Previous
• 1
• 2
• Next ›
• Page