Replies to This Discussion

Permalink Reply by Skip Peel - Mineral Consultant on February 11, 2020 at 7:35

According to the longitude and latitude, same pad slightly offset wellbore location.  Looks like a new drill as opposed to a reentry.

Permalink Reply by Skip Peel - Mineral Consultant on February 15, 2020 at 3:53

Ensign US Drilling reported the Crowell LM 3 as Waiting On Orders @ 8621' on 2/14

Permalink Reply by David Crockett on February 17, 2020 at 5:55

Skip-is “waiting on orders” a sign that they have run into a problem?  Hope not!!

Permalink Reply by Skip Peel - Mineral Consultant on February 17, 2020 at 5:57

Not necessarily.  Our geologist would have to weigh in regarding the reported depth.  Could be a number of common things.

Permalink Reply by Hydrocarbonite on February 17, 2020 at 6:00

Any word on the possible issue if they are waiting on orders? 
Sonris doesn’t even show that the well was spud yet. 

Permalink Reply by Skip Peel - Mineral Consultant on February 17, 2020 at 6:09

The reason I subscribe to a weekly rig report is that SONRIS is behind on the drilling status nine times out of ten.  The discrepancy is because the rig operator (drilling contractor is reporting to the company publishing the weekly rig report, and doing so each Friday as a means to let subs and material suppliers know where to find the rig) while the well operator is reporting to the state and can do so at their leisure.  No one in the Office of Conservation is prodding them to report.  And there is no compelling reason for the well owner to report in a timely manner.

Permalink Reply by Rock Man on February 17, 2020 at 16:29

Could be something as simple as waiting on approval to run intermediate casing.  

Permalink Reply by Lisa Melder-Johnson on February 18, 2020 at 4:47

I like the positive road for both Marathon/Southwind & me.   Thanks RM!

Permalink Reply by Skip Peel - Mineral Consultant on February 17, 2020 at 5:58

Lisa, suggest you put a live link to the well file in your discussion introduction.  That way it is at the top of each discussion page.  Sure makes things quicker and easier.

Permalink Reply by Lisa Melder-Johnson on February 20, 2020 at 7:44

How & where do you do that via a Snip It Tool File?

Permalink Reply by Skip Peel - Mineral Consultant on February 20, 2020 at 8:01

Above and to the right of your discussion title may be a button, "Options".  If so, when you click on it you will see the button to "edit".  Just cut and paste a link to the well as part of your discussion.  Then "Save".  That way it appears and is available on each page of the discussion.

Permalink Reply by Lisa Melder-Johnson on February 17, 2020 at 7:19

Hopefully all is good and they just need a management direction or approval.   They are moving along quick.

• ‹ Previous
• 1
• 2
• 3
• 4
• Next ›
• Page