Replies to This Discussion

Oil & Gas ProPermalink Reply by Les Bamburg on March 28, 2010 at 17:13

Scott, if you are referring to the following well you will notice the lateral is in Section 23 which is a Camterra operated unit.

Camterra, Thompson 23 #1 Well, Serial #241048, S14(23)-T16N-R14W

S23-T16N-R14W, HA RA SU116 Unit, Camterra, Caspiana Field, Caddo Parish

By the way, there are several instances of a well operator being different than the original unit operator. Typically this means the unit operatorship was subsequently assigned to the new operator.

• ▶ Reply

landownerPermalink Reply by Spring Branch,mineral owner on March 28, 2010 at 23:22

Scott, if you are a newbie, what Les B. is telling you is: On the Camterra well, The well pad is in Section 14, but the lateral will be drilled into and produced from Section 23.

• ▶ Reply

Permalink Reply by Scott on March 29, 2010 at 13:17

Well that's good news. Were you able to determine this through Sonris?

• ▶ Reply

Oil & Gas ProPermalink Reply by Skip Peel - Mineral Consultant on March 29, 2010 at 13:52

From the SONRIS Well Scout under Scout Info:

1400' FEL & 82.5' FSL OF SEC 14. PBHL: 660' FEL & 150' FSL OF SEC 23.

Surface location 1400' From East Line & 82.5' From South Line of Section 14

Planned Bottom Hole Location 660' From East Line & 150' From South Line of Section 23.

• ▶ Reply

Permalink Reply by Scott on March 29, 2010 at 13:53

Thanks guys.

• ▶ Reply

landownerPermalink Reply by sesport on March 29, 2010 at 16:21

Question re. this ...

"Planned Bottom Hole Location 660' From East Line & 150' From South Line of Section 23."

It was my understanding that the distance from a section line had to be 330 feet. Am I confusing planned bottom hole with something else? Just tryng to wrap my brain around a mental image, haven't found one of those colorful visual aides yet.

thanks 80)

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on March 29, 2010 at 16:34

Sesport, the PBHL can be closer than 330' from the section line but the last perforation has to be at least 330' from the section line.

• ▶ Reply

landownerPermalink Reply by sesport on March 29, 2010 at 16:47

Thank uuuuuuu!!1 80)

• ▶ Reply

Oil & Gas ProPermalink Reply by Les Bamburg on March 29, 2010 at 14:22

Scott, yes- I was able to obtain the information from Sonris.

• ▶ Reply

Permalink Reply by Scott on March 30, 2010 at 1:56

Thanks Les.

• ▶ Reply